| 1. |
Remove the rear wheel & tire.the rear
wheel & tire.
Tightening
torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0Kgf.m, 65.1 ~
79.6lb-ft)
|
|
Be careful not to damage to the hub
bolts when removing the front wheel &
tire. | |
| 2. |
Loosen the bolt & nut and then disconnect
the shock absorber(A) with the rear axle.
Tightening
torque :
137.3 ~ 156.9N.m(14.0 ~ 16.0Kgf.m, 101.3
~ 115.7lb-ft)
|
|
| 3. |
Loosen the shock absorber mounting
bolts(A).
Tightening
torque :
49.0 ~ 63.7N.m(5.0 ~ 6.5Kgf.m, 36.2 ~
47.0lb-ft)
|
|
| 4. |
Installation is the reverse of
removal. |
| 1. |
Check the rubber parts for damage or
deterioration. |
| 2. |
Check the shock absorber for abnormal
resistance or unusual sounds. |
Disposal
| 1. |
Fully extend the shock absorber
rod. |
| 2. |
Drill a hole to remove gas from the cylinder.
|
The gas coming out is harmless, but be
careful of chips that may fly up when drilling. Be sure to use
face shield and safety
goggles. | | |
